Left front steering knuckle Clio 3 RS Phase 1 / Phase 2

Product introduction

This used Renault Sport left front steering knuckle is intended for the Renault Clio 3 RS Phase 1 and Phase 2. An essential part of the front axle, it constitutes a suitable base for overhaul, repair or preparation on a sports vehicle.

Purpose of the part

The left front steering knuckle, also called hub carrier, provides the connection between the suspension, the wheel hub, the braking system and the steering. It allows precise support of the left front wheel while accompanying suspension movements and steering angles. On Clio 3 RS, this part directly contributes to the rigor of the front axle and the dynamic behavior of the vehicle.

Symptoms or consequences of a worn or defective part

• Abnormal play at the wheel or hub.
• Premature or irregular wear of the tyre.
• Vibrations, rolling noises or clicking noises in the front axle.
• Degradation of steering precision.
• Geometry difficult to adjust or poor handling.

Benefits of replacement

• Allows you to restore the rigidity and precision of the front axle.
• Contributes to the correct positioning of the hub, the disc and the brake caliper.
• Solution suitable for a repair with an original Renault Sport part.
• Suitable for restoration after impact, wear or corrosion.
• Preserves the original sporting behavior of the Clio 3 RS.

Specifications

• Brand: Renault Sport.
• Product: left front steering knuckle.
• Position: front left, driver's side.
• Condition: used product.
• Compatible model: Clio 3 RS Phase 1 and Phase 2.
• Assembly advice: product to be sanded before refitting.
• Recommended maintenance: bearing to be replaced.
• Information: second-hand product, general condition check recommended before assembly.

Vehicle compatibility

• Renault Clio 3 RS Phase 1.
• Renault Clio 3 RS Phase 2.

Conclusion

This used Renault Sport left front steering knuckle for Clio 3 RS constitutes an ideal technical part for rehabilitating the front axle while maintaining a configuration consistent with the original, subject to prior preparation and replacement of the bearing.