Clio 2 RS Phase 1 / Phase 2 / Phase 3 driveshaft support

Renault Sport driveshaft holder for Clio 2 RS Phase 1, Phase 2 and Phase 3

This used Renault Sport driveshaft support is intended for Renault Clio 2 RS equipped with the 2.0 16V engine. This is a mechanical part allowing the maintenance and correct positioning of the transmission, particularly useful during an overhaul, a driveshaft replacement or a front axle repair.

Purpose of the part

The driveshaft support maintains the driveshaft and contributes to the proper alignment of the transmission between the gearbox and the wheel hub. It helps to limit parasitic movements of the transmission assembly and allows regular operation of the driveshaft, particularly during acceleration, deceleration and load change phases.

Symptoms or consequences of a worn or defective part

• Vibrations felt in the front axle or in the body.
• Abnormal noises in the transmission.
• Poor holding of the driveshaft or excessive play.
• Premature wear of the universal joint, the bearing or associated elements.
• Less precise behavior during hard acceleration.

Benefits of replacement

• Restores correct transmission retention.
• Improves the reliability of the driveshaft and front axle assembly.
• Reduces the risk of vibrations and mechanical noise.
• Allows repair consistent with the original Renault Sport architecture.
• Solution suitable for the maintenance or repair of a Clio 2 RS.

Specifications

• Product: gimbal support.
• Brand: Renault Sport.
• Condition: used product.
• Assembly: transmission part / front axle.
• Part intended for Renault Clio 2 RS.
• Product sold second-hand, it is recommended to consult all the photos before purchasing.

Vehicle compatibility

• Renault Clio 2 RS Phase 1.
• Renault Clio 2 RS Phase 2.
• Renault Clio 2 RS Phase 3.

Before ordering, it is advisable to check that the part corresponds to the assembly present on your vehicle.

Conclusion

This used Renault Sport universal joint support is a suitable part for the maintenance, repair or bringing the transmission of a Clio 2 RS into conformity, while maintaining an assembly close to the original.