MONIT ABS wiring harness for 2-wire sensor (analogue output)

The ABS wiring harness designed for a two-wire sensor with analogue output is specially suited to vehicles equipped with ABS. It picks up the signal from the ABS sensor and converts it into a format compatible with your Monit system. This wiring harness is compatible with most two-wire sensors or probes producing an analogue output signal.

Warning: The Monit ABS interface is STRICTLY reserved for competition use and prototypes. It must not be used on a vehicle that retains its original ABS sensors. Ignoring this recommendation can cause significant damage to your vehicle and/or injury in the event of a safety system malfunction.

Technical specifications:

• Hysteresis voltage: 200 mV
• Maximum input frequency: 4 kHz
• Input impedance: 100 KΩ
• Operating temperature: from -20 to 125 degrees Celsius